Digital Equipment Corporation Storage Works Guide de l'utilisateur Page 59

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 74
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 58
SCSI Bus Signal Converters
6.4 Terminating SCSI Buses
Figure 6–2 End-Bus DWZZA Bus Terminators
SINGLE-ENDED
SCSI-2 TERMINATION
DIFFERENTIAL
TERMINATOR
RESISTOR SIPS
68-PIN
CONNECTOR
J2
CXO-3836A-MC
5. Terminate the SCSI–P cable by installing the five resistor single-inline-
packages (SIPs).
6. Replace the SBB cover and bezel or replace the desktop cover.
7. Label the SBB bezel or the desktop cover with the status of both the
differential terminator and the single-ended terminator as either "IN" or
"OUT."
8. Install the SBB, in the shelf, connect the SCSI cable, and apply power to the
shelf.
9. Observe the system to determine if the SCSI bus and devices are functioning
properly.
SCSI Bus Signal Converters 6–7
Vue de la page 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 73 74

Commentaires sur ces manuels

Pas de commentaire